Oppo Reno 7 Series Stops By TENAA Ahead Of Launch; Key Features Confirmed

(Last Updated On: November 24, 2021)

Oppo Reno 7 series is all set to break covers tomorrow in China. The company will be unveiling the Reno7 SE and the Reno 7 Pro alongside the vanilla Reno 7. Giznext had recently shared the complete spec sheet of the Reno 7 Pro. Now, right ahead of the official launch, all three models have cleared their certification via Chinese mobile regulatory TENAA. The spec-sheet shared on the certification website of all three models corroborates with the recent leaks and rumors including our exclusive report.

Oppo Reno 7, Reno 7 Pro Specifications Revealed Via TENAA

Starting with the vanilla Reno 7, the handset bears the PFJM10 model number and is listed with 156.8 x 72.1 x 7.59 mm dimensions. The smartphone is listed with a 6.43-inch AMOLED display with 1080p FHD+ resolution. The exact processor isn’t listed, but the listing reveals up to 12GB RAM and 256GB native storage capacity.

The standard Reno 7 will offer three rear cameras comprising a 64MP OmniVision OV64B main lens, an 8MP ultra-wide-angle sensor, and a 2MP sensor. The handset will have a 32MP Sony IMX709 selfie snapper tucked inside the punch-hole upfront. The certification website also confirms a 4,390 mAh rated capacity battery.

On the other hand, the Reno 7 Pro is listed with a bigger 6.55-inch AMOLED FHD+ display. The camera setup here will also be slightly different with the primary sensor being a 50MP Sony IMX766 sensor, an 8MP ultra-wide-angle sensor, and a 2MP lens. The selfie snapper remains the same as the vanilla model. The website mentions a 2,200 mAh dual-cell battery and up to 12GB RAM configuration. The storage capacity here would be up to 256GB.

Oppo Reno 7 SE Specifications Also Listed On TENAA

As mentioned earlier, the TENAA certification website has also revealed the key features of the Reno 7 SE alongside the Reno 7 and the Reno 7 Pro. This low-end model in the Reno 7 series bears the PFCM00 model number and has 160.2 x 73.2 x 7.45mm dimensions.

The Reno 7 SE’s display would measure 6.43-inches. It will be an AMOLED panel like the remaining variants with an FHD+ resolution and a punch-hole camera cutout. The TENAA listing hasn’t confirmed this variant’s processor as well. However, it does reveal up to 8GB RAM and 256GB storage configuration.

The Reno 7 SE rear camera module will house a 48MP main lens accompanied by a pair of 2MP sensors. The selfie snapper would be smaller here compared to the remaining variants, i.e, a 16MP sensor. Lastly, the battery capacity listed is 4,390 mAh (rated capacity).

About Sandeep Sarkar

As a senior sub-editor, Sandeep is generating tech-oriented content and also monitoring the content published on the website. He has over five years of experience in tech journalism and has expertise in product reviews, news articles, campaign articles, and listicles.

View all posts by Sandeep Sarkar →

Leave a Reply

Your email address will not be published. Required fields are marked *